Share
Pin
Tweet
Send
Share
Send
Functional and decorative: you will always find fruit in its designated place.
DESCRIPTION OF WORK
1. To increase a lemon, leaflets, and also a support from a sheet of motives to the corresponding size. Using carbon paper, transfer the lemon motif and the stand onto the plywood, transfer the leaves to thinner glued plywood, and cut them out using a jigsaw or circular saw. Using sandpaper or sanding pad, process sections and rough surfaces (Fig. 1).
2.All primed parts should be primed with white acrylic paint diluted in a 1: 1 ratio. Leave the primer to dry completely. If necessary, remove rough fibers from the surface with sandpaper. Then paint the lemon and the stand with a dark yellow paint.In a still wet paint, add a little yellow and white acrylic tint with a sponge. Paint the leaves with dark green acrylic paint, for tinting add a little light green and brown paint (Fig. 2).
3.Acc. photo stick stand on a lemon. On the back side of the stand, additionally screw two small wood screws for strength. While the glue dries, cut a 38 x 8 cm part from the wire mesh. Wrap the lemon with the stand with a wire mesh, starting on one side so that the mesh protrudes slightly, and fix with a stapler with two or three brackets. Tighten the grate slightly above the stand and also fix it on the opposite side with a stapler. Carefully beat the brackets with a hammer (Fig. 3).
4.Turn the composition, if necessary, trim the grid and fix along the edge with a stapler. To hang, attach a loop to the lemon in the middle (Fig. 4).
5.Hang the lemon on the wall, then glue the green leaves to the lemon with wood glue.
Model from Burda Special Edition "My Favorite Hobby" 01/2014
Photo: burdastyle.
Material prepared by: Elena Karpova
Share
Pin
Tweet
Send
Share
Send